Siemens SINUMERIK 840D sl Function Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

DB21, ...DBX319.5 Repos DEFERAL ChanEdge evaluation: No Signal(s) updated: CyclicallySignal state 1 All axes currently controlled by this channel have either no REPOS offset or their REPOS offsets areinvalid.Signal state 0 Miscellaneous.Corresponding to ... DB31, ... DBX70.0 (Repos offset)DB21, ...DBB376 ProgEventDisplayEdge evaluation: No Signal(s) updated: Event-drivenNote: Signal duration of at least one complete PLC cycleAll bits == 0: There is no event-driven program call activeMeaning of individual bits:Bit Meaning0 Part program start from channel state "Reset"1 Part program end2 Operator panel reset3 Startup4 1st start after block search5 - 7 Reserved, currently always 0Signal state 1 The event assigned to the bit has activated the "Event-driven program call" function.Signal state 0 The event assigned to the bit has not activated the "Event-driven program call" function or the event-driven user program has expired or was canceled with RESET.DB21, ...DBX378.0 ASUB is activeEdge evaluation: No Signal(s) updated: Event-drivenSignal state 1 One ASUB is active.Note:The user gets a feedback on a running ASUB through DB21, … DBX378.0 even outside FC9 block.Signal state 0 No ASUB is active.DB21, ...DBX378.1 Still ASUB is activeEdge evaluation: No Signal(s) updated: Event-drivenSignal state 1 An ASUB with suppressed display updating (refer to MD20191 $MC_IGN_PROG_STATE_ASUP) isactive.Signal state 0 No ASUB with suppressed display updating is active.Z1: NC/PLC interface signals19.6 Mode group, channel, program operation, reset response (K1)Basic Functions1626 Function Manual, 01/2015, 6FC5397-0BP40-5BA2