J. Charging Wire1. OutlineThe primary, pre-transfer, transfer/separation charging wires are located around thephotosensitive drum. (The wire diameter is 0.06 mm.)2. Removing the Primary Charging Assembly Wire Cleaner1) Hold the wire cleaner, and disengage it with a flat-blade screwdriver.Figure 4-3233. Installing the Charging WireThe charging wire (except the grid wire) is installed in the same way for all chargingassemblies. (The following cites the primary charging assembly.)1) Remove the shielding plate (left, right) of the charging assembly.Be sure to remove the left and right shielding plates individually to preventdeformation of the primary charging assembly. (At the same time, take care not toloosen the mounting screw q on the left/right shielding plate.)Figure 4-3242) Remove the wire cleaner.For other assemblies, remove the lid (2 pcs.).qCOPYRIGHT © 1997 CANON INC. CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 4 IMAGE FORMATION SYSTEM4-49Caution:
