10) Remove the eight mounting screws e, and disconnect the two connectors r; then,remove the pick-up drive assembly.Figure 7-455K. Duplexing Unit Drive 1 Assembly1. ConstructionFigure 7-4562. Removing the Duplexing Unit Drive 1 Assembly1) Open the front door, and slide out the holding tray assembly about 10 cm from thecopier.2) Remove the rear cover.3) Remove the DC controller PCB.eeeerCOPYRIGHT © 1997 CANON INC. CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS7-40
