2. Removing the Sensor from the Holding Tray1) Open the front cover, and slide out the holding tray feeding assembly to the front.2) Remove the mounting screw q and the metal fixing w; then, remove the holding trayfeeding sensor cover e from the bottom of the holding tray feeding assembly.Figure 5-899Do not open the holding tray upper feeding guide more than it is designed to open;otherwise, the stopper r will be damaged.3) Remove the two mounting screws, and disconnect the connector; then, remove thesensor assembly from the holding tray feeding assembly.When installing the holding tray feeding sensor cover, be sure that the two springsare in the bosses behind the holding tray upper feeding guide.qwerCOPYRIGHT © 1997 CANON INC. CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 5 PICK-UP/FEEDING SYSTEM5-104Caution:Caution:
