K. Developing AssemblyThe copier’s developing assembly is not equipped with a protection cover, requiringyou to be careful not to damage the developing assembly after removing thedeveloping assembly.Be sure not to install the developing locking assembly if the developing assemblyis not set in the copier. The toner collecting in the path from the hopper to thedeveloping assembly could move astray because of the vibration occurring duringinspection/ repair work.1. Removing from the Developing Assembly1) Open the multifeeder door, and remove the mounting screw; then, remove the doorstopper tape.2) Remove the mounting screw q, and push the developing locking assembly w in thedirection of the arrow to remove.Figure 4-3353) Disconnect the connector e, and pull out the developing assembly r carefully fromthe copier.Figure 4-336e rwqCOPYRIGHT © 1997 CANON INC. CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 4 IMAGE FORMATION SYSTEM4-55Caution:
