IPP (Internet Printing Protocol)263Target computersThe following computers support IPP.NOTE: For Internet printing from a Windows Me computer, the IPP port should beinstalled. For the IPP port installation, see the Windows Me documentation.IPP InstallationUse the following procedure to install and use the machine in an IPP environment.Installation ProcedureThere are three stages.Network Communication SetupThe machine needs to be set up for IPP.Computer SetupThe computer needs to be configured to submit print data to the machine.Test PrintA print job should be submitted to make sure that the machine has been installed andconfigured correctly.Network Communication SetupThis section describes how to set up the network communication parameters for themachine.At the machine, perform these steps.NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IPnetwork.NOTE: Some of the configuration options for this protocol are only available fromCentreWare Internet Services. Refer toCentreWare Internet Services on page 147.Initially, enable the IPP port.1. Connect the machine to the network.2. Press the button on the control panel, and then type the SystemAdministrator login ID to enter the System Administration mode.NOTE: The passcode may also be required depending on the machine configuration.3. Press the button on the control panel, and then select the[Tools] tab on the screen.4. Select [System Settings] in the menu at the left side of the screen.5. Select [Connectivity & Network Setup] in the [Group] menu.Connection OS ProtocolIPP port Windows 2000Windows XPWindows Server 2003Windows MeWindows VistaTCP/IP
