8 Printer Environment Settings2264) Select [Configuration Report].5) Press the button on the machine.4. Read the Configuration Report to confirm that an IP address has been allocatedand that it is a valid IP address on your network.NOTE: If the IP address starts with 169.xxx.xxx.xxx, then the DHCP server has notproperly allocated an address or DHCP is not enabled on your network.5. Record the IP address allocated.6. From a computer, open a web browser (such as Internet Explorer), and then enterthe machine’s IP address. If connected properly, you should see the CentreWareInternet Services web page for your machine.NOTE: CentreWare Internet Services is a powerful tool for configuring the machineremotely. The default user ID is "11111" and the passcode is "x-admin". The username and passcode are case sensitive and should be changed after install.7. Load the print drivers on the computers that will be accessing the machine.Quick Network Setup (Static IP)Prerequisites for Manual Setup of the Network Using a Static IP AddressNOTE: On startup, the WorkCentre multifunction machine defaults to DHCP to obtainits network configurations, so DHCP must be turned off by manually entering a staticIP address.Before installing, record the following information for use during setup:Procedure for Manual Setup of the Network Using a Static IP Address1. Power on the machine.2. Press the button on the control panel, and then type the SystemAdministrator login ID to enter the System Administration mode.NOTE: The passcode may also be required depending on the machine configuration.3. Press the button on the control panel, and then select the[Tools] tab on the screen.4. Select [System Settings] in the menu at the left side of the screen.5. Select [Connectivity & Network Setup] in the [Group] menu.6. Select [Protocol Settings] in the [Features] menu.7. Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].When [IPv4 Mode] or [Dual Stack] is selected in step 78. Select [IP Address Resolution], and then [Change Settings].9. Select [STATIC], and then select [Save].TCP/IP Address:Gateway Address:Subnet Mask (for IPv4) / Prefix (for IPv6):DNS Server Address:
