Loading the Booklet Staples in the Office Finisher LX (Optional)37Loading the Booklet Staples in the Office Finisher LX (Optional)If the optional Booklet Maker is installed, a message appears on the touch screen whenthe unit runs out of staples. When the message is displayed, load a new staplecartridge into the Booklet Maker. The Booklet Maker contains two staple cartridges.1. Make sure that the machine isnot operating, and open theside cover of the finisher.2. Hold the tabs on both sides ofthe booklet staple cartridgeand pull the cartridge out of thefinisher.3. Hold the tabs on both sides ofthe new booklet staplecartridge, and insert it into theoriginal position until it clicks.NOTE: If you have trouble insertingthe cartridge, make sure that thestaples in the cartridge are properlyin place.4. Repeat steps 2 and 3 to replace the other booklet staple cartridge.5. Close the side cover of the finisher.NOTE: If the side cover is not completely closed, a message will appear and themachine will not operate.Emptying the Hole Punch Waste Container (Optional)The Hole Punch Unit for the Office Finisher LX contains a hole punch waste container.When the hole punch waste container becomes full, a message appears on the touchscreen. When the message is displayed, empty the hole punch waste container.Make sure to discard all paper chads when emptying the hole punch waste container.If you do not empty the container completely, the container becomes full before a
