8 Printer Environment Settings2646. Select [Port Settings] in the [Features] menu.7. Select [IPP], and then [Change Settings].8. Select [Port Status], and then [Change Settings].9. Select [Enabled], and then [Save].Next, establish TCP/IP.1. Select [Connectivity & Network Setup] in the [Group] menu, and then select[Protocol Settings] in the [Features] menu.2. Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].When [IPv4 Mode] or [Dual Stack] is selected in step 23. Select [IP Address Resolution], and then [Change Settings].4. Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],[DHCP/Autonet], and [STATIC], and then select [Save].NOTE: Use the DHCP server together with the Windows Internet Name Server(WINS) server.If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocolsettings. Otherwise, proceed to step 11.5. Select [IPv4 - IP Address], and then [Change Settings].6. Use the keypad on the screen to enter an IP address for the machine in the format“xxx.xxx.xxx.xxx”. When you have finished entering all values, select [Save].7. Select [IPv4 – Subnet Mask], and then [Change Settings].8. Using the same method as in step 6, enter a subnet mask.9. Select [IPv4 – Gateway Address], and then [Change Settings].10. Using the same method as in step 6, enter a gateway address.NOTE: If you do not wish to set the gateway address, leave this field blank.11. Select [IPv4 – IP Filter], and then [Change Settings].12. Select [Enabled] to filter access to the machine.NOTE: If you do not wish to use the IP filter feature, select [Disabled].NOTE: Use CentreWare Internet Services to register the IP addresses which are notallowed to access the machine. Refer toCentreWare Internet Services on page 147.13. When you have finished establishing TCP/IP, select [Close] on the [ProtocolSettings] screen.When [IPv6 Mode] or [Dual Stack] is selected in step 23. Set [IPv6 Address Manual Configuration].NOTE: Select [Enabled] when the machine is connected to a network on which IPv6stateless address autoconfiguration is disabled, or when you want to set a static IPv6address.If you selected [Enabled] in step 3, proceed to step 4. Otherwise, proceed to step 10.4. Select [Manually Configured IPv6 Address], and then [Change Settings].
