8 Printer Environment Settings2325. Repeat the test for all computers that will be sending jobs to the machine.The installation process is now complete.If the test print fails, refer toProblem Solving chapter on page 341.UNIX TCP/IPThis section explains how to set up the machine to operate in a UNIX TCP/IPenvironment. The UNIX Workstation Operating Systems (OS) supported are Solaris,SunOS, and HP-UX. The following information is provided:Information Checklist – page 232UNIX TCP/IP Environments – page 233UNIX TCP/IP Installation – page 233Installation Procedure – page 233Network Communication Setup – page 233Workstation Setup – page 235Test Print – page 239Printing – page 240Solaris/HP-UX – page 240SunOS – page 241Printer Status – page 243Solaris/HP-UX – page 243SunOS – page 244-C Option – page 245Information ChecklistBefore installing the UNIX TCP/IP features on the machine, make sure that thefollowing items are available or have been performed.If you encounter problems during the installation of the machine, refer toProblemSolving chapter on page 341.Item ByAn existing operational network utilizing a UNIX TCP/IP protocol isrequired. These steps are not designed to install the UNIX TCP/IPnetwork.CustomerSunOS 4.1x, Solaris 1.x, 2.x, 7.x, 8.x, 9.x, 10.x, HP-UX 9.x, 10.x, 11.x CustomerMake sure that the correct IP Address is being used for the machine. CustomerMake sure that the Gateway Address is set correctly. CustomerMake sure that the Subnet Mask (for IPv4) or Prefix (for IPv6) is setcorrectly.CustomerMake sure that the Host Name is set correctly. CustomerTest the machine to make sure that it is fully installed and functioningcorrectly.Customer
