TCP/IP (LPD or Port9100)255Computer SetupInstall the print driver on the client computer. Refer to the HTML document on the PCLPrint Driver CD-ROM.Test PrintMake sure the machine has been installed on the network correctly by submitting a testprint from each client computer. Perform the following steps.1. Open a document on a client computer.2. Select the machine as the printer.3. Print the document on the machine and verify that it prints correctly.4. Make sure that the print driver is installed on every computer that will be sendingjobs to the machine.5. Repeat the test for all computers that will be sending jobs to the machine.The installation process is now complete.If the test print fails, refer toProblem Solving on page 341.TCP/IP (LPD or Port9100)This section explains how to set up the machine to print from a Windows computerthrough LPD or Port9100. The following information is provided:Information Checklist – page 255TCP/IP (LPD or Port9100) Environments – page 256TCP/IP (LPD or Port9100) Installation – page 256Installation Procedure – page 256Network Communication Setup – page 257Computer Setup – page 257Test Print – page 257Information ChecklistBefore starting these procedures, make sure that the following items are available orhave been performed.Item ByAn existing operational network utilizing TCP/IP is required. Theseprocedures are not designed to install a network.CustomerObtain and record the following information:• IP address• Gateway address• Subnet mask (for IPv4) / Prefix (for IPv6)• Host nameCustomerTest the machine to make sure that it is fully installed and functioningcorrectly.CustomerInstall the print driver. Customer
