Toshiba GR200 Series Instruction Manual

Also see for GRB200: Instruction manual

6F2S1931 (0.20)Centralized GRB200(Soft: 030, 031, 032, 033, 034)- 572 -(ii) U16_01 signalPLC U16_01 signal (Signal No. 230302 3112011BB0) being originally prepared for generalpurpose is also reserved for expressing the other quality information for possible generalpurpose. It is configured in the PLC function, but its default signal has not been mapped forIEC61850 LNs (that is, it is mapped for LNs depending when it is required). The behavior ofU16_01 is almost the same as the behavior of Qual_validity, but the failure and inaccurate ofDetail quality can also be set.Figure 10.3-32 Structure of U16_01 signalNote: The validity of U16_01 signal is only affected by signals of SERI_ERR andMINR_ERR of from the MNT_LOGIC function block (see ChapterAutomaticsupervision: Supervision of task operation). When errors occur, SERI_ERR signal can be generated if Serious and Serious(Comm) are set for the settings [CHK_xxx:Lvl]. On the other hand, MINR_ERR signal can be generated if Minor, Alarm,Warning are set for the settings [CHK_xxx:Lvl]. The SERI_ERR signal includes ‘invalid’ and ‘failure’ in the detail quality. The MINR_ERR signal includes ‘questionable’ and ‘inaccurate’. The SERI_ERR and MINR_ERR signals are exclusive one. Table 10.3-9 shows the combination of validity and detail quality.Table 10.3-9 Combinations of validity and detail quality (U16_01)Cases Validity Detail quality Notes1 invalid Failure2 questionable inaccurate≥10 0 0Kinds ofValidityoverflowoutOfRangebadReferenceoscillatoryfailureoldDatainconsistentinaccuratesourcetestoperatorblockedQual_Validity0 0 0 0 0 0 0 0Detail qualitySERI_ERRTest Mode220001 3110111001220001 3110121001201301 3100001190301001 3110041005MINR_ERRKinds of ValueValidityGood 00Invalid 01Questionable 11