Toshiba GR200 Series Instruction Manual

Also see for GRB200: Instruction manual

6F2S1931 (0.20)Centralized GRB200(Soft: 030, 031, 032, 033, 034)- 243 -Table 3.8-5 Mapping signals required for LLNO object in MDCTRL01 functionObject_reference Attribute Type FC Signal Number Signal NameSystem/LLN0$Mod$SBOw ctlVal Mod CO5500017013016D08 MDCTRL01_CONTROL_REQSystem/LLN0$Mod$SBOw ctlNum INT8U COSystem/LLN0$Mod$SBOw T Timestamp COSystem/LLN0$Mod$SBOw Test BOOLEAN COSystem/LLN0$Mod$SBOw Check Check COSystem/LLN0$Mod$SBOw$origin orCat orCategory COSystem/LLN0$Mod$SBOw$origin orIdent Octet64 COSystem/LLN0$Mod$Oper ctlVal Mod COSystem/LLN0$Mod$Oper ctlNum INT8U COSystem/LLN0$Mod$Oper T Timestamp COSystem/LLN0$Mod$Oper Test BOOLEAN COSystem/LLN0$Mod$Oper Check Check COSystem/LLN0$Mod$Oper$origin orCat orCategory COSystem/LLN0$Mod$Oper$origin orIdent Octet64 COSystem/LLN0$Mod$Cancel ctlVal Mod COSystem/LLN0$Mod$Cancel ctlNum INT8U COSystem/LLN0$Mod$Cancel T Timestamp COSystem/LLN0$Mod$Cancel Test BOOLEAN COSystem/LLN0$Mod$Cancel$origin orCat orCategory COSystem/LLN0$Mod$Cancel$origin orIdent Octet64 COSystem/LLN0$Mod ctlModel ctlModel CFSystem/LLN0$Mod sboTimeout INT32U CFSystem/LLN0$Mod sboClass sboClass CF†Note: The attribute is defined in the IEC 61850 standard; “CO” stands for “Control”and “CF” stands for “Configuration” in the functional constraint (FC).Check “Input”Figure 3.8-5 Input-point mapped for LLNO