Toshiba GR200 Series Instruction Manual

Also see for GRB200: Instruction manual

6F2S1931 (0.20)Centralized GRB200(Soft: 030, 031, 032, 033, 034)- 311 -BO1_SOURCE200B01 310200E11DFunction key logic for F1(Function ID: 240001)PLC connection point in BO1≥1&[BO1_CPL]OffOn& DRIVER BO1Signal designated bysetting [Input signal 1][Input signal 2][Input signal 3][Input signal 4][Input signal 5][Input signal 6][Input signal 7][Input signal 8]Signal to thedevice≥1“BO1”(200B01_8002001112)“BO1-RB”(200B01_8002001113)BO1 circuit at IO_SLOT1 (Function ID: 200B01)Terminal andwireTo contact healthcheckF1Pressing the F1 key“F1 SIGNAL”(240001_ 3100001737)Setting Data ID “F1SIGNAL” for the[Input signal 1]Setting Data ID“BO1_SOURCE”for the [Signal]†[Logic] Instant&Toggle“FUNC-KEY1”(240001_ 3100001730)&Figure 4.6-3 F1 key connected with the BO1‡‡Note:The BO1 circuit is used just for an explanation; it is discussed in ChapterTechnical description: Binary IO module.†Note:When the user wishes to inject the signal at the PLC connection point of the “BO1-SOURCE (200B01 31200E11D at the IO#1 slot)”, the user should set the BO1-SOURCE (200B01 31200E11D) for the setting [Signal] of the F1 key. Then, set Offfor the scheme switch [BO1_CPL]The user can select either Toggle or Instant modes for the signal generation using schemeswitch [LOGIC], as shown in Table 4.6-4. Thus, the user can substitute “F1-SIGNAL (240001310001737)” for the “FUNC-KEY1 SIGNAL (240001 310001730)”, provided the Toggle modeis preferred. In the Table 4.6-7 the other FUNC-KEY2 to FUNC-KEY7 are shown.Table 4.6-4 Signal mode selection using setting [LOGIC]Setting Generated signal corresponding to pressing the function keyTogglePressing KeyBinary signalInstantPressing KeyBinary signal(iii) Lighting LEDs on F1 to F7Figure 4.6-4 shows the F1 to F7 LED logics. Programing to light the LEDs (F1 to F7) is thesame as the programing of the LED indicators (#3 to #26) (for the programming, see section4.6.2). As a default, e.g., the “FUNC-KEY1 (240001 310001730)” is set for the setting [Inputsignal 1] of the F1 LED logic. The LED-F2 to F7 points are listed in Table 4.6-8.