Siemens SINAMICS G150 Manual

Also see for SINAMICS G130: Operating instructions Operating instructions List manual Operating instructions Operating instructions

Contents

2 Parameters2.2 List of parametersSINAMICS G130/G150966 List Manual (LH2), 04/2014, A5E03263479ADescription: Displays the calculated data memory utilization rates based on the existing target topology.Index: [0] = Fast data memory 1[1] = Fast data memory 2[2] = Fast data memory 3[3] = Fast data memory 4[4] = ReservedDescription: Displays the measured data memory utilization rates based on the existing target topology.Index: [0] = Fast Memory 1[1] = Fast Memory 2[2] = Fast Memory 3[3] = Fast Memory 4[4] = HeapDescription: Displays the utilization of the data memory by OA applications.Index: [0] = Fast Memory 1[1] = Fast Memory 2[2] = Fast Memory 3[3] = Fast Memory 4[4] = ReservedDescription: Displays the calculated DRIVE-CLiQ system load based on the existing target topology.The values are not made available until the RUNUP READY (800) state is adopted (see p3988).Index 0 ... 7 corresponds to DRIVE-CLiQ socket X100 ... X107.r9982[0...4] Data memory utilization / Mem_util dat_memCU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: - Calculated: - Access level: 3Data type: FloatingPoint32 Dyn. index: - Func. diagram: -P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting- [%] - [%] - [%]r9983[0...4] Measured data memory utilization (actual load) / Mem_ut dat_mem msCU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: - Calculated: - Access level: 4Data type: FloatingPoint32 Dyn. index: - Func. diagram: -P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting- [%] - [%] - [%]r9984[0...4] Data memory utilization OA / Mem_ut dat_mem OACU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: - Calculated: - Access level: 3Data type: FloatingPoint32 Dyn. index: - Func. diagram: -P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting- [%] - [%] - [%]r9986[0...7] DRIVE-CLiQ system load / DQ system loadCU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: - Calculated: - Access level: 3Data type: FloatingPoint32 Dyn. index: - Func. diagram: -P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting- [%] - [%] - [%]