Siemens SINAMICS G150 Manual

Also see for SINAMICS G130: Operating instructions Operating instructions List manual Operating instructions Operating instructions

Contents

4 Faults and alarms4.2 List of faults and alarmsSINAMICS G130/G1501766 List Manual (LH2), 04/2014, A5E03263479AA35417 (F, N) TM: Temperature alarm threshold channel 11 exceededMessage value: %1Message class: External measured value / signal state outside the permissible range (16)Drive object: B_INF, TM150, VECTOR_GReaction: NONEAcknowledge: NONECause: The temperature (r4105[11]) measured using the temperature sensing of the Terminal Module 150 (TM150) hasexceeded the threshold value to initiate this alarm (p4102[22]).Note:For sensor type "PTC thermistor" and "Bimetallic NC contact" (p4100[11] = 1, 4), the following applies:- if r4101[11] > 1650 ohms, the temperature r4105[11] = 250 °C- if r4101[11] <= 1650 ohms, the temperature r4105[11] = -50 °CAlarm value (r2124, interpret decimal):Temperature actual value at the time of initiation [0.1 °C].Remedy: Allow the temperature sensor to cool down to below p4102[22] - hysteresis (p4118[11]).See also: p4102Reaction upon F: NONEAcknowl. upon F: IMMEDIATELY (POWER ON)Reaction upon N: NONEAcknowl. upon N: NONEN35800 (F) TM: Group signalMessage value: -Message class: General drive fault (19)Drive object: B_INF, TM150, TM31, TM54F_MA, TM54F_SL, VECTOR_GReaction: Vector: OFF2 (IASC/DCBRK, NONE, OFF1, OFF3, STOP2)Infeed: OFF2 (NONE, OFF1)Acknowledge: NONECause: The Terminal Module has detected at least one fault.Remedy: Evaluates other actual messages.Reaction upon F: Vector: OFF2 (IASC/DCBRK, NONE, OFF1, OFF3, STOP2)Infeed: OFF2 (NONE, OFF1)Acknowl. upon F: IMMEDIATELYA35801 (F, N) TM DRIVE-CLiQ: Sign-of-life missingMessage value: Component number: %1, fault cause: %2Message class: Internal (DRIVE-CLiQ) communication error (12)Drive object: B_INF, TM150, TM31, TM54F_MA, TM54F_SL, VECTOR_GReaction: NONEAcknowledge: NONECause: A DRIVE-CLiQ communication error has occurred between the Control Unit and the Terminal Module involved.Fault cause:10 (= 0A hex):The sign-of-life bit in the receive telegram is not set.Note regarding the message value:The individual information is coded as follows in the message value (r0949/r2124):0000yyxx hex: yy = component number, xx = error causeRemedy: - check the DRIVE-CLiQ connection.- replace the component involved.See also: p9916 (DRIVE-CLiQ data transfer error shutdown threshold slave)Reaction upon F: NONEAcknowl. upon F: IMMEDIATELYReaction upon N: NONEAcknowl. upon N: NONE