Siemens SINAMICS G150 Manual

Also see for SINAMICS G130: Operating instructions Operating instructions List manual Operating instructions Operating instructions

Contents

2 Parameters2.2 List of parametersSINAMICS G130/G150734 List Manual (LH2), 04/2014, A5E03263479A131: Milliamperes peak-to-peak132: Millifarads133: Meter135: Kilowatt hours136: Percent137: Amps / Volt138: Volt139: Millivolts140: Microvolts141: Amps142: Milliamperes143: Micro amps144: Milliamperes rms145: Millimeter146: Nanometer147: JoulesDescription: Displays the actual serial number of the memory card.The individual characters of the serial number are displayed in the ASCII code in the indices.Dependency: Refer to: p9920, p9921Notice: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.Note: Example: displaying the serial number for a memory card:r7843[0] = 49 dec --> ASCII characters = "1" --> serial number, character 1r7843[1] = 49 dec --> ASCII characters = "1" --> serial number, character 2r7843[2] = 49 dec --> ASCII characters = "1" --> serial number, character 3r7843[3] = 57 dec --> ASCII characters = "9" --> serial number, character 4r7843[4] = 50 dec --> ASCII characters = "2" --> serial number, character 5r7843[5] = 51 dec --> ASCII characters = "3" --> serial number, character 6r7843[6] = 69 dec --> ASCII characters = "E" --> serial number, character 7r7843[7] = 0 dec --> ASCII characters = " " --> serial number, character 8...r7843[19] = 0 dec --> ASCII characters = " " --> serial number, character 20r7843[20] = 0 decSerial number = 111923EDescription: Displays the version of the firmware stored on the memory medium of the drive device.Depending on the drive device being used, the memory medium is a memory card, or an internal non-volatile devicememory.Index: [0] = Internal[1] = External[2] = Parameter backupr7843[0...20] Memory card serial number / Mem_card ser.noCU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: - Calculated: - Access level: 1Data type: Unsigned8 Dyn. index: - Func. diagram: -P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting- - -r7844[0...2] Memory card/device memory firmware version / Mem_crd/dev_mem FWCU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: - Calculated: - Access level: 1Data type: Unsigned32 Dyn. index: - Func. diagram: -P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting- - -