Siemens SINAMICS G150 Manual

Also see for SINAMICS G130: Operating instructions Operating instructions List manual Operating instructions Operating instructions

Contents

2 Parameters2.2 List of parametersSINAMICS G130/G150812 List Manual (LH2), 04/2014, A5E03263479A[10] = PZD 11[11] = PZD 12[12] = PZD 13[13] = PZD 14[14] = PZD 15[15] = PZD 16[16] = PZD 17[17] = PZD 18[18] = PZD 19[19] = PZD 20[20] = PZD 21[21] = PZD 22[22] = PZD 23[23] = PZD 24[24] = PZD 25[25] = PZD 26[26] = PZD 27[27] = PZD 28[28] = PZD 29[29] = PZD 30[30] = PZD 31[31] = PZD 32Note: IF2: Interface 2Value range:0 - 242: Byte offset255: Not assignedDescription: Selects bits to be sent via interface 2.The individual bits are combined to form status word 1.Index: [0] = Bit 0[1] = Bit 1[2] = Bit 2[3] = Bit 3[4] = Bit 4[5] = Bit 5[6] = Bit 6[7] = Bit 7[8] = Bit 8[9] = Bit 9[10] = Bit 10[11] = Bit 11[12] = Bit 12[13] = Bit 13[14] = Bit 14[15] = Bit 15Dependency: Refer to: p8888, r8889p8880[0...15] BI: IF2 binector-connector converter status word 1 / Bin/con ZSW1B_INF, CU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PN, ENC,VECTOR_GCan be changed: U, T Calculated: - Access level: 3Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 2489P-Group: Communications Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting- - 0