Siemens SINAMICS G150 Manual

Also see for SINAMICS G130: Operating instructions Operating instructions List manual Operating instructions Operating instructions

Contents

SINAMICS G130/G150List Manual (LH2), 04/2014, A5E03263479A 6632 Parameters2.2 List of parameters[3] = Trace 0 PINx with block Id and PIN Id[4] = Trace 1 PINy with DO Id and chart Id[5] = Trace 1 PINy with block Id and PIN IdDescription: Selects the fourth signal to be traced.Index: [0] = Trace 0 parameter in BICO format[1] = Trace 1 parameter in BICO format[2] = Trace 0 PINx with DO Id and chart Id[3] = Trace 0 PINx with block Id and PIN Id[4] = Trace 1 PINy with DO Id and chart Id[5] = Trace 1 PINy with block Id and PIN IdDescription: Selects the fifth signal to be traced.Index: [0] = Trace 0 parameter in BICO format[1] = Trace 1 parameter in BICO format[2] = Trace 0 PINx with DO Id and chart Id[3] = Trace 0 PINx with block Id and PIN Id[4] = Trace 1 PINy with DO Id and chart Id[5] = Trace 1 PINy with block Id and PIN IdDescription: Selects the sixth signal to be traced.Index: [0] = Trace 0 parameter in BICO format[1] = Trace 1 parameter in BICO format[2] = Trace 0 PINx with DO Id and chart Id[3] = Trace 0 PINx with block Id and PIN Id[4] = Trace 1 PINy with DO Id and chart Id[5] = Trace 1 PINy with block Id and PIN Idp4733[0...5] Trace record signal 3 / Trace record sig 3CU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: U, T Calculated: - Access level: 3Data type: Unsigned32 Dyn. index: - Func. diagram: -P-Group: Trace and function generator Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 0Min Max Factory setting- - 0p4734[0...5] Trace record signal 4 / Trace record sig 4CU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: U, T Calculated: - Access level: 3Data type: Unsigned32 Dyn. index: - Func. diagram: -P-Group: Trace and function generator Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 0Min Max Factory setting- - 0p4735[0...5] Trace record signal 5 / Trace record sig 5CU_G130_DP,CU_G130_PN,CU_G150_DP,CU_G150_PNCan be changed: U, T Calculated: - Access level: 3Data type: Unsigned32 Dyn. index: - Func. diagram: -P-Group: Trace and function generator Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 0Min Max Factory setting- - 0