Siemens SINAMICS G150 Manual

Also see for SINAMICS G130: Operating instructions Operating instructions List manual Operating instructions Operating instructions

Contents

SINAMICS G130/G150List Manual (LH2), 04/2014, A5E03263479A 6252 Parameters2.2 List of parametersDescription: Sets the sensor type for Terminal Module 150 (TM150)This means that the temperature sensor type is selected and the evaluation is switched in.Value: 0: Evaluation disabled1: PTC thermistor2: KTY844: Bimetallic NC contact5: PT1006: PT1000Index: [0] = Temperature channel 0[1] = Temperature channel 1[2] = Temperature channel 2[3] = Temperature channel 3[4] = Temperature channel 4[5] = Temperature channel 5[6] = Temperature channel 6[7] = Temperature channel 7[8] = Temperature channel 8[9] = Temperature channel 9[10] = Temperature channel 10[11] = Temperature channel 11Notice: For p4102[0...23] = 251 °C, evaluation of the corresponding threshold is deactivated.For sensor type "PTC thermistor" and "Bimetallic NC contact" (p4100[0...11] = 1, 4), the following applies:To activate the corresponding alarm or fault, p4102[0...23] must be set <= 250 °C.Note: The temperature sensors are connected to the following terminals:X531 = channel 0 (for 2x2 wire evaluation, additionally channel 6)X532 = channel 1 (for 2x2 wire evaluation, additionally channel 7)X533 = channel 2 (for 2x2 wire evaluation, additionally channel 8)X534 = channel 3 (for 2x2 wire evaluation, additionally channel 9)X535 = channel 4 (for 2x2 wire evaluation, additionally channel 10)X536 = channel 5 (for 2x2 wire evaluation, additionally channel 11)Details on the wiring are included in the parameter description for p4108.Description: Sets the sensor type for Terminal Module 31 (TM31)This means that the temperature sensor type is selected and the evaluation is switched in.Value: 0: Evaluation disabled1: PTC thermistor2: KTY84Notice: For p4102[0...1] = 251 °C, evaluation of the corresponding threshold is deactivated.For sensor type "PTC thermistor" (p4100 = 1), the following applies:To activate the corresponding alarm or fault, p4102[0...1] must be set <= 250 °C.Note: The temperature sensor is connected at terminals X522.7(+) and X522.8(-).p4100[0...11] TM150 sensor type / TM150 sensor typeTM150 Can be changed: T Calculated: - Access level: 1Data type: Integer16 Dyn. index: - Func. diagram: 9626, 9627P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting0 6 5p4100 TM31 sensor type / TM31 sensor typeTM31 Can be changed: T Calculated: - Access level: 1Data type: Integer16 Dyn. index: - Func. diagram: 9576P-Group: - Units group: - Unit selection: -Not for motor type: - Scaling: - Expert list: 1Min Max Factory setting0 2 0