2. Removing the Pick-Up Roller1) Open the multifeeder paper guide.2) Remove the stop rings q from both left and right 1 (two each); then, remove theshutters w and the two rollers e (two each).Figure 5-802If the multifeeder was used at time of installation or if it was used after a long time,pick-up operation may fail.If such is the case, remove the protection sheet from the sponge roller, and dry wipethe surface of the sponge roller.3. Installing the Pick-Up RollerInstall the pick-up roller by reversing the steps used to remove it with the following inmind.• The front and rear pick-up rollers are not interchangeable.• The front pick-up roller is silver.When installing the pick-up roller q to the pick-up assembly, be sure that the roundmarking w on the collar (silver) is toward the front.q Marking (roller)w Marking (collar)Figure 5-803qwDirection ofrotationCollar (silver) Front (copier)qqww eCOPYRIGHT © 1997 CANON INC. CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 5 PICK-UP/FEEDING SYSTEM5-54Caution:
