– 134 –Chapter 8 System Menu — Setting the Control Panel AV‑HS60C1/AV‑HS60C2Setting the Control Panel AV‑HS60C1/AV‑HS60C2Settings for the main control panel and sub control panelPanel brightness and saver time can be set in each Control Panel AV-HS60C1/AV-HS60C2.@@ NOTEt Connection with the second or further Control Panel AV-HS60C1/AV-HS60C2 will be available in V2.00.00 or higher.Setting the touch buzzerThe buzzer sound during touch screen operation can be enabled/disabled.f The buzzer only activates when operating the Menu Panel AV-HS60C3.1 Select the button → [CTRL PANEL] → [Main Panel]/[SubPanel1]/[SubPanel2] tab.f The [SubPanel1]/[SubPanel2] tabs will be available in V2.00.00 or higher.2 Select an item in [Touch Sound] in the [Touch Sound] column.[On] The buzzer sound is enabled.[Off] The buzzer sound is disabled.Setting menu delegationFor details on the menu delegation function, refer to “Menu delegation function” (page 41).Setting the saver timeThe panel backlight can be automatically turned off when panel operation becomes idle for a certain period.f This setting is applied to Menu Panel AV-HS60C3, multi-selection panel, and source name display panel.1 Select the button → [CTRL PANEL] → [Main Panel]/[SubPanel1]/[SubPanel2] tab.f The [SubPanel1]/[SubPanel2] tabs will be available in V2.00.00 or higher.2 Select an item in [Saver Time] in the [Saver Time] column.[On] Backlight is turned on all the time.[Off] The backlight turns off as soon as [Off] is set. It turns on again when the panel is operated. The setting after it turns onbecomes [On].[60]*, [120]*, [180]* When no control panel operation is performed within a set time interval (60, 120, or 180 minutes), the built-in displaybacklight is turned off automatically. It turns on again when the panel is operated.* This function will be available in V2.00.00 or higher.@@ NOTEt The backlight does not turn on even if a mouse is used.Setting the panel brightness1 Select the button → [CTRL PANEL] → [Main Panel]/[SubPanel1]/[SubPanel2] tab.f The [SubPanel1]/[SubPanel2] tabs will be available in V2.00.00 or higher.2 Set [MenuPanel] in the [Brightness] column.f Adjust the brightness of the Menu Panel AV-HS60C3.3 Set [Select Panel] in the [Brightness] column.f Adjust the brightness of the multi-selection menu panel.4 Set [Source Name] in the [Brightness] column.f Adjust the brightness of the source name display panel.Setting the button colorThe lighting color for each of the Control Panel AV-HS60C1/AV-HS60C2 buttons can be set.Setting the colors when the buttons are turned onf You can select [Red], [Green], [Yellow], [Orange], and [ColorGroup1] to [ColorGroup8].1 Select the button → [CTRL PANEL] → [Button Color] tab.2 Select an item in [High Tally] in the [Select Button] column.f Set the color of the button included in the on-air output.f Applicable buttons are the KEY bus crosspoint buttons, PGM/A bus crosspoint buttons, PST/B bus crosspoint buttons, corresponding buttons from to , to buttons, and the KEY bus selector buttons (except the button and the button).
