– 97 –Chapter 5 Basic Operations — Video memoryf When [Mode] in the [Play3] column is set to [Loop], the operation of [Lead] is performed.Amount of transitionPGM-APST-BClip playback[Mode]: [Lead][Reverse]: [Off]Clip playback[Mode]: [Last][Reverse]: [On]StandbyLeadPlayback StandbyLeadPlayback StandbyLeadPlayback ReverseplaybackStandbyLastReverse playback StandbyLastReverse playback StandbyLastReverseplaybackPlaybackIn point Out pointTrimming moving imagesSet the position where the playback of the moving images is to start (IN point) and the position when it is to end (OUT point). Moving images that havebeen trimmed are played back from the IN point to the OUT point.1 Select the button → [CLIP] → [Play Clip1] to [Play Clip4] tabs.2 Select an item in the [Edit] column.f This function will be available in V2.00.00 or higher.f When [Pause] in the [Play1] column is selected after playback, moving images can be stopped at any frame.[Trim In] Sets the current frame as the IN point of trimming.[Trim Out] Sets the current frame as the OUT point of trimming.[Trim CLR] Releases the trimming settings.[ Moves one frame back from the current frame.[>Step] Moves one frame forward from the current frame.@@ NOTEt When moving images are saved to a register memory, only the trimmed portion is saved.t The same position cannot be specified for the IN point and the OUT point. The minimum unit for trimming is two frames.Layout of display iconsCurrent iconsr Current icon of still imageSelect the button on the top menu → [STILL] → [Still] tab, then the following icon is displayed at the top of the page. The icon is used forchannel selection.211 Channel nameDisplays channels from [Still1] to [Still4].2 Source with key markIndicates a source with key. This mark is displayed only for sources with key.r Current icon of moving imageSelect the button on the top menu → [CLIP] → [Play Clip1] to [Play Clip4]/[Rec] tabs, then the following icon is displayed at the top of the page.This icon is used for playback status display and channel selection.
