– 90 –Chapter 5 Basic Operations — Memory@@ NOTEt The button in the transition area on the Control Panel AV-HS60C1/AV-HS60C2 switches enabled/disabled status of the macro attachfunction assigned to the relevant buttons in the ME.- When it is turned on, the macro attach function is enabled.- The button to which the macro attach function is applied blinks while holding down the button.Key presetIt is a preset memory to store various settings for keys.Operate this memory in the KEY/DSK operation area on the Control Panel AV-HS60C1/AV-HS60C2, or operate using the button.@@ NOTEt This function will be available in V2.00.00 or higher.Operating in the KEY/DSK operation area on the Control Panel AV‑HS60C1/AV‑HS60C2Recall/register key preset memories using the KEY/DSK preset memory (<1>/<2>/<3>/<4>) buttons.r Button operationShort press: Recalls the data saved on the relevant button. (Recall)Long press: Registers the current key setting in the relevant button. (Store)r Button displayLow tally: The button recalled last time or registered last timePreset tally: Buttons on which memory is savedOff: Buttons on which no memory is savedOperating on the Menu Panel AV‑HS60C3Details of the playback target (XPT, Effect, Trans) can be selected.1 Select the button → [KEY PRESET] → [Register] tab.2 Use [ME1] to [ME2]/[DSK] in the [Select1] column, and [Key1] to [Key4] in the [Select2] column to select any key.3 Use [PMEM1] to [PMEM4] in the [Preset] column to select any preset memory.4 Select an item in the [Function] column.f Those functions are performed for the preset memory selected in the [Select1]/[Select2]/[Preset] columns.[Recall] Plays back the target.[Store] Registers the target (by overwrite).[Delete] Deletes the target.5 Select an item in the [Recall Select] column.f Select the playback target. (This setting is common to all keys.)[XPT] When set this item to [On], plays back key fill, key source, and source preset.[Key Effect] When set this item to [On], plays back the key decoration setting (content excluding the source preset (key type, keyparameter, mask settings) from the [KeySetting], [PinPAdjust], [FlyingKey], and [Chroma] tabs).[Key Trans] When set this item to [On], plays back the key transition setting (setting in the [Transition] and [KeyPattern] menus).
