|
– 46 –Chapter 5 Basic Operations — Background transitionBackground transitionSelecting a busSelect sources to be used for background transitions.1 Press the crosspoint buttons.f Depending on the operating status, the buttons pressed will light in one of three color patterns.Type Color when lit* DescriptionHigh tally [Red] Lights when the selected source is included in the on-air output.Low tally [Yellow] Lights when the selected source is not included in the on-air output butincluded in the program output.Preset tally [Green] Lights when the selected source is included in neither the on-air outputnor the program output.* Indicates the default colors. To change the colors, select the button on the top menu → [CTRL PANEL] → [Button Color] tab → [Select Button]column.f The color when lit for the buttons not selected can also be set by source or by block. (page 135)Selecting a bus using the SHIFT functionThe SHIFT function is to switch pages of the crosspoint buttons with the <2nd PAGE>/<3rd PAGE> button.There are two ways to perform the SHIFT function.All SHIFT Use the <2nd PAGE>/<3rd PAGE> button to switch all pages of buses included in the corresponding ME at once.(page 22)Single SHIFT Assign the <2nd PAGE>/<3rd PAGE> button to the crosspoint buttons to switch pages. (page 118)Using the assigned button, only the pages of individual bas can be switched.The <2nd PAGE>/<3rd PAGE> buttons are available in two modes. The setting can be changed using the menu. (page 121)[Normal] The buttons are turned on only while they are pressed.[Page Lock] The buttons are turned on and off each time they are pressed.Selecting the bus modeSet the bus operation mode. (page 121)1 Select the button → [OPERATE] → [Transition] tab.2 Select an item in [Bus Mode] in the [Bus Mode] column.[A/B] When the fader lever is at side A, the signals selected on the A bus are used as the source of the PGM bus.When the fader lever is at side B, the signals selected on the B bus are used as the source of the PGM bus.[PGM‑A/PST‑B] Using a flip‑flop system, the signals selected on the A bus are always used as the source of the PGM bus, and thesignals selected on the B bus are always used as the source of the PST bus.[PGM‑B/PST‑A] Using a flip‑flop system, the signals selected on the B bus are always used as the source of the PGM bus, and thesignals selected on the A bus are always used as the source of the PST bus.Transition operationsExecute transitions using the transition area on the Control Panel AV-HS60C1/AV-HS60C2.1 Press the button.f Select the transition target.Multiple targets can be selected by pressing the /// buttons simultaneously.2 Select the transition type.f Use the transition type selection buttons. (page 23)3 Execute the transition using the fader lever or the transition execution button.Manual transition Move the fader lever to execute the transition.Auto transition Press the button to execute the transition automatically.Cut transition Press the button to execute the transition instantaneously.f The bus tallies on the right of the PGM/A bus crosspoint buttons and the PST/B bus crosspoint buttons indicate the output status of the programbus.Lighting color DescriptionRed Lights when the relevant bus is included in the on-air output.Amber Lights when the relevant bus is not included in the on-air output but included in the program output.Off Lights when the relevant bus is included in neither the on-air output nor the program output.
|
