– 126 –Chapter 8 System Menu — System settingsSystem settingsSetting the video format functionOne system format (input/output signal) can be selected.@@ NOTEt Do not change the format during any of the following operations:- When loading from a memory card or saving to a memory card- When loading from the Storage Module AV-HS60D1 or saving to the Storage Module AV-HS60D1- When recording videos or still images1 Select the button → [SYSTEM] → [Video] tab.2 Select an item in [Video Format] in the [Video Format] column.f Select a system format. Selectable items are as follows:[1080/59.94i], [1080/50i], [1080/24PsF], [1080/23.98PsF], [720/59.94p], [720/50p], [480/59.94i], [576/50i]([1080/24PsF], [1080/23.98PsF], [720/59.94p], and [720/50p] will be available in V2.00.00 or higher.)3 Select an item in [16:9 Squeeze] in the [Video Format] column.f This setting is enabled when SD is selected as the system format.f When [16:9 Squeeze] is set to [On], a border width (wipe or PinP), which considers cases where SD format videos are converted to the 16:9aspect ratio before use, is established.[Off] Squeeze mode is not supported.[On] Squeeze mode is supported.r Border width (graphical representation) when squeeze mode is supportedSqueeze (4:3) 16:9Setting the output phaseThe phase of the output video signals can be adjusted.1 Select the button → [SYSTEM] → [Video] tab.2 Select an item in [System] in the [Output Phase] column.[1H] Output video signals are output with 1H delay to the system sync signal. When the frame synchronizer function is ON,video signals are output with a 1 frame + 1H delay.[0H] Output video signals are output in phase for the system sync signal. The frame synchronizer function is ON for all inputsignals.3 Select an item in [H‑Phase[H]] in the [Output Phase] column.f Adjust the H phase. It can be adjusted to a value from [−0.50H] to [0.49H].4 Select an item in [V‑Phase [Line]] in the [Output Phase] column.f Adjust the V phase. It can be adjusted to a value from [−100H] to [100H].r Phase adjustment setupf The line synchronizer range is the draw-in range in which automatic phase adjustment is possible.
