– 108 –Chapter 6 Input/Output Signal Settings — Setting input signals4 Select an item in [Sharp] in the [SDI IN 27]/[SDI IN 28]/[SDI IN 31]/[SDI IN 32] column.f Set the extent of the edge sharpness for the images.[3] is the standard setting. Set this closer to [1] for less sharp edges, and to [5] for sharper edges.5 Set [Size] in the [SDI IN 27]/[SDI IN 28]/[SDI IN 31]/[SDI IN 32] column.f Adjust the input image size (100% to 110%).Fine‑tuning image positionsFine-tune image positions when [Edge Crop] is selected for the scaling method.1 Select the button → [SDI IN] → [Up Converter] tab.2 Select an item in [Edge Crop Pos.] in the [SDI IN 27]/[SDI IN 28]/[SDI IN 31]/[SDI IN 32] column.[Center] Positions the image at the center, and adds a black image at the left and right.[Right] Positions the image at the right, and adds a black image at the left.[Left] Positions the image at the left, and adds a black image at the right.Setting DVI input signalsConfigure the DVI input signal setting. Signals with the available resolution are as follows.f XGA (1024×768)/60 Hz, WXGA (1280×768)/60 Hz, SXGA (1280×1024)/60 Hz, WSXGA+ (1680×1050)/60 Hz, UXGA (1600×1200)/60 Hz,WUXGA (1920×1200)/60 Hz, 1080/59.94p (1920×1080)/59.94 Hz, 1080/50p (1920×1080)/50 Hz, 1080/59.94i (1920×1080)/59.94 Hz, 1080/50i(1920×1080)/50 Hz, 720/59.94p (1280×720)/59.94 Hz, 720/50p (1280×720)/50 Hz@@ NOTEt If signals with any other resolutions or frequencies are input, the signals cannot be imported correctly.The output images in this case may be black or disturbed.t The / terminals do not support HDCP (High-bandwidth Digital Content Protection).Setting the scaling method1 Select the button → [DVI IN] → [Frame Buffer] tab.2 Select an item in [Scale] in the [DVI IN 1]/[DVI IN 2] column.f Select the scaling method.[Full] Enlarges or reduced the input image in accordance with the system resolution.(The aspect ratio is not maintained. The increased or reduced ratio in vertical and horizontal directions will differ.)[Fit‑V] Maintains the aspect ratio of the input image, and enlarges or reduces the image in accordance with the verticalresolution.[Fit‑H] Maintains the aspect ratio of the input image, and enlarges or reduces in accordance with the horizontal resolution.Setting the freeze method1 Select the button → [DVI IN] → [Frame Buffer] tab.2 Select an item in [Freeze Mode] in the [DVI IN 1]/[DVI IN 2] column.f An item can also be selected while an image is frozen.[Frame] Freezes the images frame by frame.[Field] Freezes the images field by field.Setting freeze1 Select the button → [DVI IN] → [Frame Buffer] tab.2 Select an item in [Freeze] in the [DVI IN 1]/[DVI IN 2] column.[On] Freezes the input signals.[Off] Freezes the input signals.
