– 120 –Chapter 7 CONFIG Menu — Setting the source linkSetting the source linkSetting the key couplingLinking the key fill signal and key source signalTwo modes are available for the linking setting for the key fill signal and key source signal:f [Fill to Source]: When the key fill signal (master) is selected, the key source signal (slave) changes automatically.f [Source to Fill]: When the key source signal (master) is selected, the key fill signal (slave) changes automatically.1 Select the button → [SOURCE LINK] → [Key Assign] tab.2 Select an item in [Master/Slave].[Fill to Source] Links the key fill signal (master) to the key source signal (slave).[Source to Fill] Links the key source signal (master) to the key fill signal (slave).3 Select the item to be set as the master from the left column.f Select [Master Filter] to filter the master list in the left column.4 Select the item to be set as the slave from the right column.f Select [Slave Filter] to filter the slave list in the right column.5 Select [Assign].f Make the coupling setting for the source selected as the master and the source selected as the slave.f If [Self] is set to [On] and [Assign] is selected, the same source selected for the master is coupled, regardless the item selected as the slave.@@ NOTEt When the [Master/Slave] settings are changed, the coupling setting is initialized.Linking the AUX busTwo AUX buses can be linked by the setting in “Setting the key coupling” (page 120),f The coupling combinations are the odd AUX signals and the subsequent even AUX signals, such as AUX1 and AUX2 or AUX3 and AUX4.Linking the odd AUX signals and even AUX signals1 Perform the steps 1 to 5 in “Linking the key fill signal and key source signal” (page 120).f Details of the items for the step 2 are as follows.[Fill to Source] Links the odd AUX signal (master) to the even AUX signal (slave).[Source to Fill] Links the even AUX signal (master) to the odd AUX signal (slave).2 Select the [AUX Bus Link] tab.f Enable or disable the coupling setting.3 Select an item in [AUX1/2 Link] to [AUX15/16 Link] in the [Link 1]/[Link 2] column.[Off] Disables the coupling setting.[On] Enables the coupling setting.@@ NOTEt When the [Master/Slave] settings are changed, the coupling setting is initialized.
