Page 5 - 8 Xerox Document Centre Reference GuideGroup Dial [\]Group Dial indicates that you are about to enter an identifier for agroup that has previously been setup using the Network Faxsoftware. When the job is sent, the Network Fax software will pickout the group ID and send a copy to everyone listed in that group.NOTE Using the Group Dial character, you can access a phone list that iscreated and stored on the network. Refer to the Network Faxsoftware documentation for more information.Mask Data [/]Use this character to hide information on printed reports. Charactersbetween the forward slash symbols will appear as asterisks (*). ForExample, if you require a special charge code or want to conceal acredit card number required for a call, simply use the mask datacharacter. In this example, the slashes mask a 5 digit charge code.Example: 9,5555555,/*****/ the information between the slashsymbols is masked.Password Check Switch [S]Use for remote terminal identification. This character verifies thatthe correct number has been dialed, which is very important ifsending a confidential document. A password is required beforetransmission to a remote machine. For example, 1234567S4567(where as 1234567 is the telephone number and 4567 after the S isthe ID number) instructs the machine to check for validity, which isalso known as Secure Send. The machine does not dial any numberafter the S. The number after the S is the ID number.Wait for network tone detection [W]Use to suspend dialing until an expected network tone is detected.Or it can be used to detect a specific tone when accessing an outsideline or other services.
