Page 9 - 34 Xerox Document Centre Reference GuideOut Of Staples OptionComplete job without stapling - If this option is selected, the jobwill print without stapling. Any remaining sets will be printedwithout staples.Fault/Hold job - If this option is selected, the job will be held untila staple cartridge is replaced.Any jobs requiring stapling that have not started will not print. Anyjobs in the process of printing that require stapling will be held anda fault message will display.Output Location for Non-Stapled JobsA fully featured Document Centre has a Finishing device thatcontains two output trays, the top and main tray. This feature allowsyou to select the destination of non-stapled jobs. This includesCopy, Print, and Fax jobs.For example, using this feature you can enable all incoming non-stapled print jobs to be sent to the top tray.Within Job OffsettingWhen enabled, this feature separates printed sets within a job byslightly offsetting each set. The feature can be enabled or disabledby selecting the desired button. The default is enabled.When the feature is disabled, output copies will be delivered to theoutput tray in an even stack. This is helpful when users print largevolume jobs where offsetting is not required. This feature is notrecommended for thin stapled sets (sets between 2 and 15 sheets ofpaper).
