Page 5 - 2 Xerox Document Centre Reference GuideSetting Up a Network FaxThe person responsible for installing the Document Centre to anetwork should follow these steps to set up the faxing solution.1. There are special software and hardware components required toenable the Network fax solution. You may need:l A server for the Network Fax software. If you are using anexisting server with Network Fax software, use the NetworkFax documentation to add the Document Centre to yourexisting Fax network.l Specialized hardware and software installed at theDocument Centre. Contact Xerox to ensure your machinemeets the minimum requirements and to make any requiredupgrades to your machine.2. Enable the Faxing option on the Document Centre.A Xerox technician will install any required hardware orsoftware on your Document Centre to enable the Faxing option.3. Setup the Document Centre Fax Repository settings at theDocument Centre. Refer to the next page for more information.Originals Faxed from the Document Centre are scanned andsaved to a location on the server. The fax software watches thisdirectory and faxes any files it finds to the specified destination.The identification of this repository location is part of the faxcomponent software setup. The same location must be enteredinto the Document Centre so the machine will route a faxed jobto the correct location.4. Installation is complete.
