Width rangeMedia sizeSwitch number250.0 - 306.9 mm (9.84 - 12.08 in.)A3 SEFA4/Letter LEF12 in.2100.0 - 179.9 mm (3.937 - 7.08 in.)A5Postcard3307.0 - 330.2 mm (12.09 - 13.00 in.)SRA313 in.4100.0 - 330.2 mm (3.937 - 13.0 in.)Custom5100.0 - 330.2 mm (3.937 - 13.0 in.)Custom6100.0 - 330.2 mm (3.937 - 13.0 in.)Custom7NotePositions 5, 6, and 7 must be set by the Xerox Service Representative. Contact theCustomer Support Center for more information and assistance.Miscellaneous hints and tips• System requirements messages (for example, "Order Waste Toner Container," "HolePunch Waste Container Full") may occasionally be blocked by the current UI screen.Close the Job Status screen and open the Machine Status/Supplies screen to checkconsumable status.• If the machine stops running mid-job, or does not begin printing after a job issubmitted, check the Machine Status/Supplies screen to determine if supplies needto be replaced. The system will stop if sufficient supplies are not available for asubmitted job. If the problem persists, check the Machine Status/Fault screen, selectthe fault, and click on the Instructions button.• If the machine stops running mid-job, or does not begin printing after a job issubmitted, verify that the applicable paper tray is not empty. The system will stop ifsufficient media is not available for a submitted job. If the problem persists, checkthe Machine Status/Fault screen, select the fault, and click on the Instructions button.• The system does not prohibit duplexing coated substrates from the internal trays(Trays 1-3); however, there can be a significant increase in jams or multi-feeds. Iflarge quantities of coated paper are to be run, and if it is available, the optional OHCFis recommended for paper feeding.• When using heavy coated 11 x 17 in./A3 stock, closing Trays 1-3 with too much forcewill result in a paper size misread. Open and close the tray gently to allow the papersensors to correctly identify paper size.• If the adjustment arms are disturbed while re-loading paper in Tray 5 (Bypass), thepaper size setting will return to default and cause job to stop until the paper sizesetting is corrected by the user.10-41Xerox® Color C75 PressUser GuideProblem solving
