Skew adjustment leversThe skew adjustment levers are found in all paper trays. These levers are used to improvepaper feed accuracy and to reduce paper skew problems.1. Rear skew adjustment lever2. Right-side skew adjustment lever• These levers should remain in their default position. The position of these leversshould be changed only when there is a skew problem when running a specific printjob and/or specific media type.• Changing the skew adjustment levers from their default position may cause moreskew problems when running certain media types, such as coated, label, transparency,and film.Use the following procedure to set the skew adjustment levers.1. Pull out the tray slowly until it stops.2. Slide the rear skew adjustment lever to the right.3. Gently push in the tray until it comes to a stop.4. From the Tray Properties window, enter the correct paper information, including size,type, weight, and if necessary, paper curl and/or alignment option.5. Select OK to save the information and close the Tray Properties window.6. Run your print job.• The paper is fed accurately without skew and the printed output is satisfactory;your task is complete.• The paper is skewed and the printed output is unsatisfactory; proceed to the nextstep.7. Pull out the tray slowly until it stops.13-7Xerox® Color C75 PressUser GuideOversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)
