9. Open the document feeder and turn the ID card over to copy side 2.10. Close the document feeder.11. Press Start to begin scanning side 2.Printing begins and copies are delivered to the output area.Job Assembly tabBuild JobThis feature allows you to change and save settings individually for each documentpage or stack. You can then make copies of documents with different settings as onejob.1. Split the hard-copy document into sections for individual programming.2. On the All Services screen, select Copy.3. Select the Job Assembly option.4. Select Build Job.5. Select Build Job On.6. Select Save.7. Program the job requirements for the first segment of the job by selecting and savingthe applicable features from the features shown at the bottom of the Build Jobscreen.• Copy Output• Booklet Creation• Covers• Annotations• Segment Separators• Watermark• Face Up/Down Orientation8. Load only the first segment into the document feeder or place the segment on thedocument glass one page at a time.9. Select Start.When the first segment has finished scanning, the Copy Status screen will appear.10. Remove the originals from the document feeder or document glass.11. Select Change Settings.12. Program the job requirements for the second segment.13. Load the second segment into the document feeder or on the document glass.14. Select Start.15. Repeat the previous steps until all segments of your job have been programmed andscanned.16. After the last segment has been scanned, select Last Original.The machine will complete the quantity selected.5-29Xerox® Color C75 PressUser GuideCopy
