This number indicates the specific width position set for this fuser.1This table defines five default width ranges.• Zero is the default setting. This setting indicates the full width range.• Positions 1-4 apply to specific width ranges.• The last line of the table is blank. This line is used if the customer requires the creationof a special media range (other than the ones indicated for positions 1-4). Once created,the customer writes the specific custom media range on the label.NotePositions 5, 6, and 7 are blank and reserved for custom media ranges. These positionsmust be set by the Xerox Service Representative. Contact the Customer Support Centerfor more information and assistance.2ImportantBefore installing the new fuser assembly, the width switch must be set to the specificwidth range. (If using the default setting (0), no changes are required.) Once this is done,the correct width range label must be adhered to the fuser assembly.The following table defines the media sizes and width ranges for all eight positions ofthe width switch.Width rangeMedia sizeSwitch number100.0 - 330.2 mm (3.937 - 13.0 in.)All0180.0 - 249.9 mm (7.08 - 9.839 in.)A4/Letter SEF1Xerox® Color C75 Press10-40User GuideProblem solving
