8. Return the rear skew adjustment lever to its left, default position.9. Slide the right-side skew adjustment lever toward the front of the paper tray.10. Gently push in the tray until it comes to a stop.11. From the Tray Properties window, enter the correct paper information, including size,type, weight, and if necessary, paper curl and/or alignment option.12. Select OK to save the information and close the Tray Properties window.13. Run your print job.• The paper is fed accurately without skew and the printed output is satisfactory;your task is complete.• The paper is skewed and the printed output is unsatisfactory; proceed to the nextstep.14. Pull out the tray slowly until it stops.15. Return the right-side skew adjustment lever toward the rear of the paper tray; this isits default position.16. Gently push in the tray until it comes to a stop.17. If you are still having skew adjustment problems, refer to the Advanced Stock Setupinformation located in the System Administration Guide.MaintenanceReplacing the OHCF feed rollsThe OHCF feed rolls should be replaced when experiencing frequent multifeeds, singlefeeds, or blank prints in the stack of the output prints.Use this procedure to replace the OHCF feed rolls, which includes the following rolls:• Feed Roll• Nudger Roll• Retard RollXerox® Color C75 Press13-8User GuideOversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)
