1. Select the arrow buttons to decrease or increase the trimmer setting. Adjustmentsare made in 0.1 mm/0.0039 in. increments.2. The trimmer setting is based on:• The number of sheets in the finished booklet• The finished booklet width size (such as 8.5 in./210 mm or 5.5 in./149 mm)• The media type (for example coated/uncoated, glossy)• The media weightNoteImportant! You may have to experiment with various settings in order to determine thebest settings for your particular job. Also, you may want to run one or more test printsbefore running larger jobs in order to ensure the best possible booklet output.NoteTrim settings cannot be adjusted to remove less than 2 mm (0.078 in.) or more than 20mm (0.787 in.) of edge material from the booklet. Adjustments less than 2 mm (0.078in.) may produce poor trim quality, and adjustments greater 20 mm (0.078 in.) will resultin no trimming to the booklet edge.Choose the setting that best fits your needs for the booklet output.Trim guidelinesThe following table shows various scenarios using different paper weights, media types,and trim setting selections. Use this table as a guideline when selecting a trim settingfor your specific job.NoteThe settings shown in the following table are provided as examples and are not meantto represent every possible job scenario; again, use this table as a guideline only.18-9Xerox® Color C75 PressUser GuideSquareFold Trimmer Module
