049-973Cause: HCS falsely detects that the Paper Unload button is pressed.Remedy: Perform the following:Power Off/On the machineIf the problem still exists, contact the Customer Support Center.• Open the HCS front door.• Remove any paper from the stacker cart.• Close the HCS front door.SpecificationsPaper guidelines• Stacker Tray will accept 55-350 gsm (either coated or uncoated stock) with thepossibility of degraded stock quality and increased jam rate for stocks that are heavierthan 300 gsm.• Transparencies may be run to either the Top Tray or the Stack Tray. Stack heightshould be limited to 100 transparencies.• Coated paper lighter than 100 gsm may not run as reliably as coated paper heavierthan 100 gsm.• Non-standard papers longer than 305 mm (12 in.) in the feed direction require 210mm (8.3 in.) minimum measurement across the feed direction.• Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require330 mm (13 in.) minimum measurement in the feed direction.Xerox® Color C75 Press16-26User GuideHigh Capacity Stacker (HCS)