Paper pathAs media enters the Interface Module, it is fed to the Interface Module decurler forpaper curl correction. The Interface Module decurler has both upper and lower decurlerrolls that apply pressure to the media based upon the following:• System default• Manual selections made at the Interface Module control panelBased on the paper curl (decurl) settings, the Interface Module decurler gate routes thepaper to either the up-curl (cupped) path, or the down-curl (bridged) path. The degreeof pressure is applied independently to the upward and downward decurler arms.From the Interface Module decurler, the print media is cooled and routed from theInterface Module to the optional finishing device(s) that is/are connected to yourmachine.Paper curl settings on the InterfaceModulePreset decurler settingsThe Interface Module is designed with several automated presettings for controllingpaper curl. When using these settings, the amount of curl correction is automatically setby the Interface Module decurler. Therefore, if paper curl is a problem, use one of thepreset Interface Module decurler settings in order to eliminate the problem.When the media passes through the Interface Module decurler, you are notified of thecurrent amount of curl correction through the various LEDs on the Interface ModuleControl Panel. If you require more curl correction, you can manually select curl correctionfrom the Interface Module Control Panel.15-3Xerox® Color C75 PressUser GuideInterface Module
