– 75 –Chapter 5 Basic Operations — Color correctorTone curveCorrect the tone of input images.Set the tone curve to adjust the screen brightness and contrast.Adjust R, G, and B separately to adjust white balance or tone.[Blue][Red] [Green]1: [Tone1 Black]2: [Tone2 Gray L]3: [Tone3 Gray H]4: [Tone4 White]1 Select the button → [C/C IN 25‑30], [C/C IN 31‑32], [C/C OUT] → the tab to be set.f Select the tab to be set from the [SDI IN 25] tab to [SDI IN 32] tab, or the [SDI OUT 13] tab to [SDI OUT 16] tab.2 Set [Red], [Green], and [Blue] in the [Tone1 Black]/[Tone2 Gray L]/[Tone3 Gray H]/[Tone4 White] column.[Tone1 Black] Adjusts the black level.[Tone2 Gray L] Adjusts the gray Low level.[Tone3 Gray H] Adjusts the gray High level.[Tone4 White] Adjusts the white level.3 Select an item in [RGB Link] in the [Tone1 Black] column.[Off] Enables setting of the [Tone1 Black]/[Tone2 Gray L]/[Tone3 Gray H]/[Tone4 White] column independently from RGB.[On] Uses the value of [Red] as the values of [Green] and [Blue] for the [Tone1 Black]/[Tone2 Gray L]/[Tone3 Gray H]/[Tone4White] column.@@ NOTEt The unit simply connects the set black level, gray Low level, gray High level, and white level to create a tone curve. Depending on the setting values,the tone curve might not be as desired.Adjusting the gain of color matrix1 Select the button → [C/C IN 25‑30], [C/C IN 31‑32], [C/C OUT] → the tab to be set.f Select the tab to be set from the [SDI IN 25] tab to [SDI IN 32] tab, or the [SDI OUT 13] tab to [SDI OUT 16] tab.2 Set [R‑G], [R‑B], [G‑R], [G‑B], [B‑R], and [B‑G] in the [Matrix R/G]/[Matrix B] column.[R‑G] Sets the gain value in the R-G axis direction.[R‑B] Sets the gain value in the R-B axis direction.[G‑R] Sets the gain value in the G-R axis direction.[G‑B] Sets the gain value in the G-B axis direction.[B‑R] Sets the gain value in the B-R axis direction.[B‑G] Sets the gain value in the B-G axis direction.r 12‑axis correction of the color matrixDivide the hue into 12 axis areas to adjust the amount of gain and hue for each area.RCyMg-RR-YeMgBCy-BG-CyB-MgYeGYe-G1 Select the button → [C/C IN 25‑30], [C/C IN 31‑32], [C/C OUT] → the tab to be set.f Select the tab to be set from the [SDI IN 25] tab to [SDI IN 32] tab, or the [SDI OUT 13] tab to [SDI OUT 16] tab.
