– 63 –Chapter 5 Basic Operations — KEYItem Description[Center] Makes the coordinates and rotation anglesymmetrical to the center.@@ NOTEt Do not set each other, such as selecting [Key2] in [Key1] and selecting [Key1] in [Key2] at [Target] in the [Sync] column. Normal operation may not beperformed if set each other.PinP decorationsAdd a border or soft effect to PinP.1 Select the / button → [KEY1] to [KEY4] → [PinP Adjust] tab.2 Select an item in [Border] in the [Border] column.[Off] Does not add the border effect.[On] Adds the border effect.3 Set [Width] in the [Border] column.f Sets the border width.4 Set [Soft] in the [Border] column.f Sets the amount of soft effect. When set to [0.0], the soft effect is disabled.5 Set an item in [Mode] in the [Border] column.[Fix] Keeps the border width constant.[Variable] Changes the border width to suit the PinP size.@@ NOTEt When [Border] in the [Border] column is set to [On], the amount of soft effect set using [Soft] in the [Border] column is indicated as the ratio of softeffect to the border width. To add only soft effect to PinP, set [Border] in the [Border] column to [Off].Setting the border color1 Select the / button → [KEY1] to [KEY4] → [PinP Adjust] tab.2 Adjust the color.f Set [Hue], [Sat], [Lum], or [Color Palette] in the [Border Color] column.Setting the trimmingSet the trimming type and values as well as operation for when manual is set. The default setting is as shown in the following figure.PinP effective areaArea trimmedOriginal size of PinP[Right][Left][Top][Bottom][50][40][0][−40] [−50][−50] [0] [50][−40] [40]1 Select the / button → [KEY1] to [KEY4] → [PinP Adjust] tab.2 Select an item in [Trim] in the [Trim] column.[Off] Does not perform trimming.[4:3] Trims automatically so that the aspect ratio is 4:3.[Manual] Trims using the values set with [Trim Adjust1] and [Trim Adjust2].3 Select an item in [Manual] in the [Trim] column.[Free] Sets the amount of trimming for [Left], [Right], [Top], and [Bottom] separately.[Pair] Changes the settings in such a way that the [Left] and [Right] trimming amounts, and the [Top] and [Bottom] trimmingamounts are the same. (This makes for a top-bottom and left-right symmetry.)
