|
– 50 –Chapter 5 Basic Operations — Wipef These can be set only when the target pattern is selected in the background.Either operate the fader lever or press the button to check the wipe operation.Example) When [X-Pos] is set to [−50], and [Y-Pos] is set to [−50]The next screen (or key) appears from the bottom left, and wipes in towards the center of the screen.8 Set [X‑Pos] and [Y‑Pos] in the [SQ] column.f Set the start position of the next pattern waveform.- SQ: 41, 42, 43, 44, 45f The setting and operation are the same as those in the [Wipe] column.9 Set [X‑Spin], [Y‑Spin], and [Z‑Spin] in the [Spin] column.f Set the number of rotations to be linked with the amount of transition.f This function will be available in V2.00.00 or higher.Setting the trimmingSet the trimming and transition operations. The settings are applied to the background transition.1 Select the / button → [BKGD] → [Position] tab.2 Select an item in [Trim] in the [Trim] column.f Set the trimming for the pattern waveforms of SQ, SL, and 3D.[Off] Does not perform trimming.[16:9]Trims the edges around a source at a certain amount. This setting is used when a black border is seen around thesource.The edges are trimmed at a certain amount when SD is selected as the system format.[4:3]* Performs trimming in the 4:3 aspect ratio and releases the trimming when the transition is completed.[4:3 Smooth]* Performs trimming in the 4:3 aspect ratio, and smoothly executes transition to the 16:9 video.* Enabled when HD is selected as the system format.3 Select an item in [4:3 Auto] in the [Trim] column.f Set the target sources for automatic trimming ([4:3] or [4:3 Smooth]). Enabled when HD is selected as the system format.[Off] All input sources are targeted for automatic trimming.[On] The input sources for which [Edge Crop] is selected in the up-converter setting are targeted for automatic trimming. Inputsources for which an item other than [Edge Crop] is selected are trimmed in [16:9].Setting the 3D (turn page) effectA lighting effect can be added to a wipe pattern. Alternatively, the parameters for turn page effect can be set.f These effects can be set for background transitions and key transitions.f Modify the following pattern waveforms.- 3D: 99, 100, 101, 1021 Select the / button → [BKGD] → [Modify] tab.2 Select an item in [Light] in the [Pageturn] column.[Off] Does not add the lighting effect.[On] Adds the lighting effect.3 Set [Size] in the [Pageturn] column.f Set the size for reduction.4 Set [Radius] in the [Pageturn] column.f Set the radius for the turn page effect.5 Set [Angle] in the [Pageturn] column.f Set the direction for the turn page effect.
|
