– 24 –Chapter 3 Part Names and Functions — Control Panel AV‑HS60C1/AV‑HS60C2r Transition status displayFig. 1 Fig. 2 Fig. 3 Fig. 4The transition status display at the left side of the fader lever indicates not the lever position but the amount of transition, and also works during autotransition.During pattern limitation, the amount of limitation will also be displayed. (Fig. 1)If the fader lever position and the amount of images do not match after memory playback or auto transition execution, every other display will bedisplayed. When displayed at one side (Fig. 2, Fig. 3), push the lever towards the displayed side to make the lever position recognize.If multiple operations of BKGD and KEY1 to KEY4 are performed in the next transition, both sides may become unmatched. In such a case, the displaywill be like Fig. 4, so move the fader lever back and forth to make the lever position recognize.KEY/DSK operation areasCG5V CG6V CAM1 CAM2 CG1V CG2V CG3V CG4V1234512345KEY operation area DSK operation area1 Operation target selection buttons (///////)Selects the operation target for key/DSK preset memory.Switches target to be displayed in the SEL KEYPVW output. (page 133)2 Key/DSK preset memory buttons (<1>/<2>/<3>/<4>)(This function will be available in V2.00.00 or higher.)Recalls/registers the key preset memory.f Short press: Recalls data saved to the corresponding button. (Recall)f Long press: Stores the current key settings to the corresponding button. (Store)3 /////// buttonsExecutes/cancels each key with a cut transition.4 Source name display panelsDisplays the source name selected for each key.5 /////// buttonsExecutes transition with the transition type and transition time for each key set in the menu. (pages 53, 66)Positioner area21345671 Memory card access LEDLights up while accessing the memory card.Do not turn off the power of the unit or eject the memory card while lit. The memory card or data in the memory card may be damaged.2 Memory card slotInsert an SD memory card (optional) or an SDHC memory card (optional).3 Positioner buttons (/) button Enables the X-axis operation of the positioner (horizontal direction). button Enables the Y-axis operation of the positioner (vertical direction).
