– 115 –Chapter 6 Input/Output Signal Settings — Setting MultiView displaysSDI IN 1[Tally Box][Tally Label L] [Tally Label R][Source Name]1 Select the button → [MV1‑4] → [MV1] to [MV4] tabs.2 Select an item in [Tally Group1] to [Tally Group4] in the [Tally Box]/[Tally Label L]/[Tally Label R] column.[On] Shows the tally displays.[Off] Does not show the tally displays.@@ NOTEt [Tally Label L] and [Tally Label R] will be available in V2.00.00 or higher.t If conditions overlap, the following priority order is used:[Tally Group1] > [Tally Group2] > [Tally Group3] > [Tally Group4]t To set the tally color, select the button on the top menu → [PERIPHERAL] → [Tally] tab → [Tally Group2-1] to [Tally Group4-1] columns →[Color].t For details on the tally group settings, refer to “Setting a tally” (page 136).Other display settingsSetting the level meterLevel meters for the embedded audio signals transferred by the SDI input can be displayed on the split screens.f Display on the left: Channel 1 of group 1f Display on the right: Channel 2 of group 11 Select the button → [MV1‑4] → [MV1] to [MV4] tabs.2 Select an item in [Level Meter] in the [Display] column.[Off] Does not display the level meter.[On] Displays the level meter.Setting the input signal markThe status of the input signals can be displayed in front of the source names displayed on the split screens.f [F] mark: Indicates that the input signals are frozen.f [!] mark: Indicates that there are no input signals or signals with different formats are input. If horizontal pixels are the same, false detection may occur.1 Select the button → [MV1‑4] → [MV1] to [MV4] tabs.2 Select an item in [Input Status] in the [Display] column.[On] Displays the input signal status.[Off] Does not display the input signal status.f When the [F] mark is displayed, the [!] mark is not displayed.Setting the markerSafety markers can be displayed for PGM and PVW sources of the MultiView display.1 Select the button → [MV1‑4] → [MV1] to [MV4] tabs.2 Select an item in [Marker] in the [Display] column.f Configure the marker display setting.[Off] Does not display the markers.[4:3] Displays the markers using the 4:3 aspect ratio.[16:9] Displays the markers using the 16:9 aspect ratio.3 Set [Marker Size] in the [Display] column.f Set the marker size.
