– 113 –Chapter 6 Input/Output Signal Settings — Setting output signalsItem Description System image(HD)Output image(SD)[Squeeze] Reduces the image both horizontally and vertically so that theaspect ratio is set to 4:3.[Edge Crop]Maintains the aspect ratio of the image, and reduces theimage in accordance with the vertical resolution. The image iscropped at the left and right.[Letter]Maintains the aspect ratio of the image, and reduces inaccordance with the horizontal resolution. Black images areadded at the top and bottom.5 Select an item in [Delay] in the [SDI OUT 14]/[SDI OUT 16] column.f Set the delay time of the output.[90H] ([75H])When the system format is 1080/59.94i, the image is delayed from the system image (HD) by 90H, and output.When the system format is 720/59.94p, the image is delayed from the system image (HD) by 90H+1F, and output.When the system format is 1080/50i, the image is delayed from the system image (HD) by 75H, and output.When the system format is 720/50p, the image is delayed from the system image (HD) by 75H+1F, and output.When the system format is 1080/50i or 720/50p, 75H is displayed in the menu.[1F] The image is output in-phase with a delay of 1 frame from the system image (HD). For details on the phase and delayamount, refer to “Setting the output phase” (page 126).6 Select an item from [1] to [5] in [Sharp] in the [SDI OUT 14]/[SDI OUT 16] column.f Set the extent of the edge sharpness for the images. Set this closer to [5] for sharper edges.
