02/20003-22 DocuPrint N2125IQ RAP 12 , IQ RAP 13Initial IssueImage Quality Repair Analysis ProceduresY NReplace the Fuser Assembly (REP 6.2).Panic stop the printer half way through the print cycle. Look at the image on the drum. Theimage on the drum has even density.Y NReplace the Laser Assembly (REP 7.4).Look at the print on the paper before the Fuser. The print on the paper has even density.Y NReplace the BTR (REP 7.1).Replace the Fuser Assembly (REP 6.2).IQ RAP 13 Skewed ImageThe image is not parallel to the edges of the print sheet (Figure 1).Figure 1 Skewed ImageInitial Actions• Check the paper tray(s) installation and the paper in the tray(s).• Load fresh dry paper.• Paper meets specification.• Check the paper path for any obstructions or debris that might hamper the passage of thepaper.• Ensure the Print Cartridge is properly installed.ProcedureRun 5 test prints, single sided, from each paper tray. If the printer has a Duplex Assembly, runfive duplexed prints from each tray. The skewed image appears only on duplexed prints.Y NThe skewed image occurs on prints fed from all trays.Y NThe skewed image occurs on prints fed from the MBF Tray.Y NThe skewed image occurs on prints fed from Tray 1.Y NThe skewed image occurs on prints fed from Tray 2.Y N• Check the Tray 3 Feed Rolls. Clean or replace if necessary.• Check the Tray 3 Retard Roll. Clean or replace if necessary.• Check the Nudger Roll. Clean or replace if necessary.• Check the Tray 3 Transport Rolls. Check for obstructions or con-tamination. Clean as necessary.• Check the feed chute between Tray 3 and Tray 2. Check forobstructions or contamination. Clean as necessary.A B C D E
