02/20004-63DocuPrint N2125 REP 9.9, REP 9.10Repair-AdjustmentInitial IssueREP 9.9 Front Interlock Switch AssemblyParts List on PL 10.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover (REP 1.7).6. Remove the Left Plate Assembly (REP 1.11).7. Disconnect P/J284 from the LVPS PWB (REP 9.5).8. Release the switch harness from all cable clamps.9. Remove the two screws that secure the Front Interlock Switch Assembly to the printer(Figure 1).10. Remove the Front Interlock Switch Assembly (Figure 1).Figure 1 Front Interlock Switch AssemblyReplacement1. Reinstall the components in the reverse order.REP 9.10 Rear Interlock Switch AssemblyParts List on PL 10.1RemovalCAUTIONThese components are susceptible to electrostatic discharge. Observe all ESD procedures toavoid damage.WARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover (REP 1.7).6. Remove the Top Cover Assembly (REP 1.4).7. Open the Rear Cover Assembly.8. Remove the Interlock Cover (REP 1.10).9. Remove the Left Plate Assembly (REP 1.11).10. Remove the Exit Chute Assembly (REP 6.4).11. Disconnect P/J30 from Print Engine Controller PWB.12. Release the Harness from all cable clamps (Figure 1).13. Remove the two screws that secure the Rear Interlock Switch Assembly to the printer(Figure 1).14. Remove the Rear Interlock Switch Assembly (Figure 1).Figure 1 Rear Interlock Switch AssemblyReplacement1. Reinstall the components in the reverse order.
