02/20004-43DocuPrint N2125 REP 6.1, REP 6.2Repair-AdjustmentInitial IssueREP 6.1 Transport Chute AssemblyParts List on PL 6.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Front Cover Assembly (REP 1.6).4. Remove the Left Front Cover (REP 1.7).5. Remove the MBF Chute Assembly (REP 4.1).6. Remove the Paper Handler Assembly (REP 5.1).7. Remove the BTR Assembly (REP 7.1).8. Remove the screw that secures the DTS Wire (white) to the Transport Chute Assembly(Figure 1).9. Remove the screw that secures the TR Wire (red) to the Transport Chute Assembly (Fig-ure 1).10. Use care not to drop high voltage contact springs when chute is removed (Figure 1).11. Remove the two screws that secure the Transport Chute Assembly to the printer (Figure1). Remove Assembly.Figure 1 Transport Chute AssemblyReplacement1. Reinstall the components in the reverse order.REP 6.2 Fuser AssemblyParts List on PL 6.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.The Fuser may be hot.1. Open the Rear Cover Assembly.2. Remove Duplex Assembly (if installed).3. Remove the two thumb screws that secure the Fuser Assembly to the printer and removethe Fuser (Figure 1).Figure 1 Fuser AssemblyReplacement1. Reinstall the components in the reverse order.
