02/20006-36 DocuPrint N2125GP 3.7 , GP 3.8Initial IssueGeneral Procedures / Information• FUSER PAUSE command issuedFuser Temperature Cycling (Table 1)GP 3.8 Erase CycleThe printer immediately interrupts a print cycle whenever the Front or Rear Covers are opened,there is a paper jam, Tray 1 is removed, or the printer power is switched off. When you removethe cause of the print cycle interruption, such as closing the covers, clearing the paper jam,reinstalling the Paper Tray, or switching on printer power, the printer runs an Erase Cycle beforecontinuing with the next print cycle.During an Erase Cycle, the printer switches on the Main Motor Assembly and the BCR (AC andDC), BTR(-) and DB (DC) voltages. The Erase Cycle removes any developed image (toner) onthe drum, and any latent image (electrical) on the drum. When the Erase Cycle finishes, theprinter returns to normal mode and is ready to resume printing.Table 1 Fuser Temperature CyclingTemperature Name Temperature ValueHigh Trouble Temperature Approximately 215 °C (Standby temperature + approximately35 °C)Fuser Off Temperature Fuser control temperature +/- 0 °CFuser Control Temperature(NVRAM Code 09=08)Standby temperature (180 °C)Running temperature (180 °C)Fuser On Temperature Fuser control temperature - 2 °CLow Trouble Temperature Approximately 155 oC (Standby temperature - approximately25 °C)
