02/20004-97DocuPrint N2125 REP 12.8, REP 12.9Repair-AdjustmentInitial IssueREP 12.8 Motor AssemblyParts List on PL 13.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Duplex Assembly (REP 12.1).2. Remove the Duplex Cover (REP 12.3).3. Remove the Drive Cover (REP 12.5).4. Disconnect P/J38 from the Duplex PWB (Figure 1).5. Remove the harness from all cable clamps (Figure 1).6. Remove the two screws that secure the Motor Assembly (Figure 1).7. Remove the Motor Assembly (Figure 1).Figure 1 Motor AssemblyReplacement1. Reinstall the components in the reverse order.REP 12.9 Rear Roll AssemblyParts List on PL 13.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Duplex Assembly (REP 12.1).2. Remove the Turn Chute Assembly (REP 12.2).3. Remove the Duplex Cover (REP 12.3).4. Remove the Drive Cover (REP 12.5).5. Remove the Motor Assembly (REP 12.8).6. Release the locking tab and remove the Rear Belt Stopper (Figure 1).7. Remove the Duplex Gear (Figure 1).8. Remove Gears 17 and 18 (Figure 1).9. Release the locking tabs and remove both the left and right bearings (Figure 1).10. Move the Rear Roll Assembly forward, then to the left until the right end is free (Figure 2).11. Remove the Rear Roll Assembly (Figure 2).Figure 1 Locking Tab and Rear Belt Stopper
